Does the Emfit QS system accurately measure nocturnal HR and HRV compared to an ECG-based reference device in healthy participants?
The Emfit QS contact-free monitoring system provides accurate nocturnal HR and HRV data with small mean bias compared to ECG, though it is associated with a higher rate of missing data.
Background Heart rate (HR) and heart rate variability (HRV) measurements are widely used to monitor stress and recovery status in sedentary people and athletes. However, effective HRV monitoring should occur on a daily basis because sparse measurements do not allow for a complete view of the stress-recovery balance. Morning electrocardiography (ECG) measurements with HR straps are time-consuming and arduous to perform every day, and thus compliance with regular measurements is poor. Contact-free, ballistocardiography (BCG)-based Emfit QS is effortless for daily monitoring. However, to the best of our knowledge, there is no study on the accuracy of nocturnal HR and HRV measured via BCG under real-life conditions. Objective The aim of this study was to evaluate the accuracy of Emfit QS in measuring nocturnal HR and HRV. Methods Healthy participants (n=20) completed nocturnal HR and HRV recordings at home using Emfit QS and an ECG-based reference device (Firstbeat BG2) during sleep. Emfit QS measures BCG by a ferroelectret sensor installed under a bed mattress. HR and the root mean square of successive differences between RR intervals (RMSSD) were determined for 3-minute epochs and the sleep period mean. Results A trivial mean bias was observed in the mean HR (mean –0.8 bpm beats per minute, SD 2.3 bpm, P=.15) and Ln (natural logarithm) RMSSD (mean –0.05 ms, SD 0.25 ms, P=.33) between Emfit QS and ECG. In addition, very large correlations were found in the mean values of HR (r=0.90, P<.001) and Ln RMSSD (r=0.89, P<.001) between the devices. A greater amount of erroneous or missing data (P<.001) was observed in the Emfit QS measurements (28.3%, SD 14.4%) compared with the reference device (1.1%, SD 2.3%). The results showed that 5.0% of the mean HR and Ln RMSSD values were outside the limits of agreement. Conclusions Based on the present results, Emfit QS provides nocturnal HR and HRV data with an acceptable, small mean bias when calculating the mean of the sleep period. Thus, Emfit QS has the potential to be used for the long-term monitoring of nocturnal HR and HRV. However, further research is needed to assess reliability in HR and HRV detection.
Vesterinen et al. (Sun,) studied this question.