Key points are not available for this paper at this time.
The phase transformations in an as-cast Fe-30Mn-8.8Al-0.3Si-0.15C steel were analyzed experimentally and numerically with a Calphad-based method during heat treatment. The nonequilibrium phases were determined using the Thermo-Calc Scheil module and the equilibrium phases with Themo-Calc based on the steel chemical composition. The precipitated phases were analyzed with TC-PRISMA using the chemical composition, nucleation site, and temperature among other factors. An ingot of this chemical composition was vacuum-melted using pure elements under an Ar gas atmosphere. As-cast steel specimens were annealed and solution-treated, quenched, and then aged at different temperatures. Heat-treated specimens were analyzed by different techniques. The results indicated that the microconstituents are the α and γ phases for the as-cast, homogenized, and quenched conditions. The main difference among these conditions is the distribution and size of the γ phase, which produced a change in hardness from 209 to 259 VHN. In contrast, the aging treatment at 750 °C caused a decrease in hardness from 492 to 306 VHN, which is attributable to the increase in volume fraction of the γ phase. On the other hand, the aging treatment at 550 °C promoted precipitation hardening from 259 to 649 VHN because of the κ precipitate formation. The calculated results for the different heat treatments with the Calphad-based method agreed well with the experimental ones. In addition, the intragranular precipitation of the κ phase could be simulated using the nucleation and growth and coarsening mechanisms based on a Calphad method.
López-Hirata et al. (Tue,) studied this question.