Key points are not available for this paper at this time.
In order to solve the existing problem of low efficiency of multi-layer and multi-pass welding methods for thick stainless steel clad plate (SSCP), this paper proposes high-power laser-arc hybrid welding (HP-LAHW) single-pass weld thick SSCP. The effects of wire feeding rate (WFR) on the weld's composition distribution, microstructure and mechanical properties were investigated. The weld morphology is nail-shaped, consisting of a wide arc zone (ArcZ) within the stainless steel layer and a long narrow laser zone (LaserZ), mainly in the carbon steel layer. With the increase of WFR, the dilution rate of the carbon steel layer to the ArcZ decreases first and then increases. The influence of WFR on the microstructure and mechanical properties of the weld is observed mainly in the ArcZ. When the WFR reaches 6 m/min, the composition of the microstructure within the ArcZ will change from martensite, ferrite, and a small amount of granular austenite to ferrite and a small amount of austenite, resulting in the microhardness of the ArcZ decreasing rapidly from 398 HV to 210 HV. The solidification type and microstructure transformation mechanisms within the weld were elucidated based on quantitative calculations of the chromium and nickel equivalent ratios. The microstructure of the LaserZ in all welds is predominantly martensitic due to the rapid cooling rate, which makes the tensile properties of the weld higher than the base metal (BM). The results of this study provide technical support for realizing high-efficiency and high-performance single-pass HP-LAHW of thick SSCP.
Cao et al. (Tue,) studied this question.