Key points are not available for this paper at this time.
FORGE (Frontier Observatory for Research in Geothermal Energy) is an underground field laboratory located in Utah, western United States, and sponsored by the US Department of Energy. The FORGE site is situated above a young, hot granitoid formation. The site has been used as a testbed for institutions interested in enhanced geothermal systems. As part of recent research work conducted at the site, a new deviated well was drilled adjacent to a previously stimulated well. Both wells were drilled into the granite volume. Circulation tests were performed over a period of approximately two days following completion of the second well. The circulation tests were monitored with two distributed optical sensing systems. One of the systems was recording in the new well and included measurements of distributed acoustics (DAS), temperature (DTS) and strain (DSS). The other system recorded from a preexisting well located about 500 m away and consisted of DAS measurements in a vertical cable. Over the duration of the circulation tests, the two DAS systems detected on the order of 250 microseismic events in the close vicinity of the new well. A preliminary analysis of this group of events in terms of their hierarchical clustering allowed the selection of a small subset of them, which was used for the joint inversion of their absolute location and a layered velocity model for the site. The two-well DAS data of some of the events with absolute location was then used as a reference to estimate relative locations for the rest of the events catalogue. The estimated relative locations display a SW-NE alignment approximately perpendicular to the orientation of the new deviated well within the depth range of about 2300m to 2500m measured from the ground level. The location uncertainties more often show longer horizontal elongations suggesting a better depth constraint compared to the epicentral locations. DTS data was analyzed in conjunction with slow strain data derived from the DAS data. Following the circulation tests, a ramp-like feature was observed beginning at approximate 1500m migrating upward throughout time in the slow strain data potentially indicating preferential fluid flow at this depth. Slow strain data is inextricably tied to temperature due to the thermal elongation of fiber, and as such, a thermal anomaly with similar characteristics is also observed at this depth. However, similar warming trends exist at various intervals throughout the well without the accompanied slow strain response indicating a truly anomalous interval that features unique DTS and slow strain response.
Staněk et al. (Mon,) studied this question.