Current saw- and pin-type lint-cleaning systems used by the ginning industry have challenges retaining lint quality. The objective of the research was to test a novel pneumatic fractionator for the lint cleaning of an Upland cotton variety that was both saw- and roller-ginned. The process variables tested were initial lint moisture content in the range of 5.5–15% w.b., line pressure in the range of 276–552 kPa, and residence time in the range of 15–45 s. Experiments were conducted based on a central composite design. Models based on response surface methodology (RSM) were developed for final lint moisture, total trash extracted during lint cleaning, and High-Volume Instrument (HVI) fiber quality. The RSM models adequately described the pneumatic fractionation process, as indicated by the coefficient of determination, predicted vs. observed plots, and residual values. The results indicated that the interactions among initial lint moisture content, residence time, and line pressure significantly affected lint quality. At the optimized pneumatic fractionator process conditions, the predicted lint quality attributes were better for both roller- and saw-ginned lint compared to lint cleaned with saw- and pin-type lint cleaners. The upper half mean length increased by 1 mm, the uniformity index was higher by 0.5–1 percentage points, the strength was 1–2 g/tex higher, and the short fiber content was reduced by more than one percentage point. Color grades were better for pneumatic fractionated lint compared to saw- and pin-type lint cleaning methods. Lint value was approximately 4 cents/kg higher for both saw- and roller-ginned pneumatic fractionated lint, compared to lint cleaned using saw- and pin-type lint cleaners. The novel pneumatic fractionator, when compared to industry-standard saw- and pin-type lint cleaners, effectively cleaned lint while retaining fiber quality and removing most of the motes and trash.
Tumuluru et al. (Wed,) studied this question.