ABSTRACT This study aimed to elucidate the relationships between sectional velocity, pedaling rate, and gear ratio with performance outcomes in the 200‐m qualifying race in track cycling (200mTT). High‐speed video footage (120 Hz) was collected at three Japanese championships in 2024, analyzing 38 male cyclists. Sectional velocities, pedaling rates, and gear ratios were derived from the footage. The track was divided into ten 20‐m segments for the timed section; flying‐start segments were estimated using visual markers and cubic spline interpolation. Cyclists were categorized into four performance groups based on 200mTT times: top (TG), middle‐high (MHG), middle‐low (MLG), and low (LG). The TG exhibited significantly higher velocities than other groups from −135 m onward and maintained this advantage throughout the trial ( P < 0.05). They also achieved a steady 2% velocity increase during the flying‐start phase and demonstrated more consistent pacing with reduced velocity fluctuations across curved and straight segments. Despite comparable gear ratios between TG and MHG, differences in acceleration timing and strategy led to divergent outcomes. Partial correlation analysis controlling for initial velocity confirmed that higher gear ratios independently contributed to greater maximum velocity. In contrast, the magnitude of velocity decrement had minimal influence on race time. These findings underscore the importance of optimizing both technique and conditioning to enhance maximal velocity. The trend toward higher gear ratios highlights the need for earlier well‐timed acceleration during the flying‐start phase. These insights offer guidance for aligning gear selection and acceleration strategies with cyclists' physical characteristics to improve 200mTT performance.
Ikeda et al. (Thu,) studied this question.