The amount of scrap steel and selection of blowing process parameters are known to influence the fluid flow characteristics of the melt pool in converter steelmaking. However, few studies have considered the effects of scrap steel and blowing process parameters together. In this study, a physical model of a converter is established to investigate the influences of the amount of scrap steel and bottom-blowing process parameters on the fluid flow characteristics of the melt pool. Particle image velocimetry is used to measure the velocity distribution in the melt pool, and the stimulus–response method is used to measure the mixing time of the melt pool under different operating conditions. The results show that increasing the scrap steel ratio worsens the dynamic conditions of the melt pool. The best of the explored combinations is achieved at a scrap steel ratio of 20% and with six nozzles. The mixing time decreases as the gas flow rate increases, but the rate of decrease also decreases. Based on the results, the mixing time can be predicted from the gas flow rate and the number of nozzles. A relationship between the stirring power and mixing time of a converter using the bottom-blowing process is established.
Yuan et al. (Thu,) studied this question.