As a prevalent integrated structure-insulation system, sandwich insulation wall panels have emerged as a critical structural configuration for zero- and nearly zero-energy green buildings, owing to their high construction efficiency and superior thermal insulation performance which directly aligns with the core goals of sustainability and sustainable energy utilization in the built environment. However, connectors penetrate the insulation layer and form systematic thermal bridges, which cause substantial heat loss and become a key bottleneck limiting further improvement in the overall thermal performance of wall systems. This study established three-dimensional numerical models of sandwich insulation wall panels with four typical connectors (fiber-reinforced polymers (FRPs), clamp-type stainless steel, plate-type stainless steel, and truss-type stainless steel) using Ansys Fluent 2021R1. The model reliability was verified by calibrated hot-box experiments, with relative errors between simulation and experimental results ranging from 2.1% to 16.1%. Systematic numerical simulations were then performed to investigate the effects of connector type, insulation material, climate zone, inner–outer temperature difference, connector quantity, and wall dimensions on the thermal bridge effect. The results indicated that FRP connectors caused the minimal heat flux increment (only 0.27%), followed by clamp-type stainless steel connectors (9.59%), while plate-type and truss-type stainless steel connectors led to significant increments (27.17% and 27.62%, respectively). The lower the heat transfer coefficient (K-value) of the wall was, the more prominent the connector-induced thermal bridge effect was. Within the typical temperature difference range, the heat flux increment of each connector remained stable, and polyurethane (PU) insulation exhibited a more significant inhibitory effect on thermal bridges than extruded polystyrene (XPS) under the same K-value. Linear fitting formulas for the relationship between wall K-value/temperature difference and the heat flux correction coefficient were derived, with high goodness-of-fit. The maximum impact of connectors on wall thermal performance did not exceed 30%. This study provides theoretical support and design references for the selection of connectors, material optimization, and thermal performance calculation of sandwich insulation wall panels, contributing to the promotion of energy-saving building envelope technologies.
Zhang et al. (Wed,) studied this question.
Synapse has enriched 5 closely related papers on similar clinical questions. Consider them for comparative context: