A single-substrate-layer Frequency Selective Surface (FSS) is designed with a 1.6 mm thick FR4 substrate for triple band-stop frequency filtering applications, that are for Bluetooth, WLAN, WiMAX, and X-band. The proposed FSS unit cell consists of two polygon loops on the front side and a square loop with four annular rings attached to its corners on the backside. The offered design covers three frequency bands: 2.3-4 GHz, 5-6 GHz, and 8-12 GHz. There are three resonances at 3.3 GHz, 5.6 GHz, and 9.9 GHz. The equivalent circuit model of the proposed structure and the formulas of the LC parameters were presented. A prototype of this structure was manufactured in size of 26 cm × 26 cm and experimentally verified in the antenna and microwave laboratory. The software used for design and simulation is HFSS from Ansys, which uses the finite element method. A comparison with similar structures was performed to demonstrate the performance of the proposed structure. The advantages of the proposed filter include adequate bandwidth, simple structure, as well as small size. In addition, it is unaffected by variant angles of incidence for TE polarization and TM polarization. Furthermore, due to its symmetrical design, it shows a polarization-independent feature. Experimental results for both polarizations verify the merits of the proposed approach, as shown before in the simulation results as well.
Nadjari et al. (Sun,) studied this question.