Immersion cooling has been widely investigated in battery thermal management due to its high cooling efficiency; however, the influence of coolant properties on the thermal behavior and temperature uniformity of large-capacity energy storage battery modules remains unclear. In this study, a three-dimensional numerical model is developed to investigate the thermal performance of an immersion-cooled battery module consisting of 52 prismatic cells. The cooling performance of silicone oil (SO), synthetic hydrocarbon (SH), and two synthetic esters (SE) with different viscosities is systematically compared under various discharge rates and volumetric flow rates. The battery thermal model was validated through single-cell experiments under natural air convection conditions. The research results indicate that at a 0.5C discharge rate, the 30 cSt SE achieves a reduction in maximum battery pack temperature of 6.3% and 7.0% compared to SO and SH, respectively. Furthermore, the maximum temperature difference is significantly reduced by 22.9% and 25.4% under the same conditions. Due to differences in the inherent properties and flow heat transfer characteristics of the coolant, at a volumetric flow rate of 12 L/min, the 30 cSt SE resulted in a 15.8% reduction in module temperature difference compared to the 20 cSt SE. To further evaluate the internal thermal balance of the battery module, two thermal uniformity indicators were introduced to quantify the consistency of the highest temperature of individual cells and the internal temperature difference. Considering both the temperature performance and thermal uniformity at the module level, from a heat dissipation performance perspective, the 30 cSt SE demonstrates significant potential for thermal management of large-scale prismatic battery packs.
Zhao et al. (Thu,) studied this question.