Key points are not available for this paper at this time.
Carbide cutting tools, which are inexpensive and widely used by machine shops, are alternatives for performing hard machining, yet limitations due to their low strength requires performance evaluation as well as appropriate selection of cutting parameters. In this study, a carbide tool with TiAlN coating with wiper geometry at the cutting edge is proposed for performing mild range of hard machining of martensitic stainless steel (48 HRC). The tool's performance was evaluated based on its tool life and the resulting surface finish when hard machining at various cutting speeds and feeds and at constant depth of cut without using cutting fluid (dry machining). Response surface methodology was used to quantify the effect of cutting speed and feed to the tool life and proposing the optimum cutting parameters. Further observation was made on the worn tool, the machined surface, and the generated chip to observe the process. Results showed that the wiper coated carbide tool are capable of performing particular hard machining.
Kurniawan et al. (Fri,) studied this question.