Observation of an Ablating Surface in Expansion Tunnel Flow

The observation of an ablating surface in expansion tunnel flow was reported. A one-dimensional (1-D) semi-infinite analysis was performed using an empirical estimation of the stagnation-point heat flux. A surface temperature change for epoxy of 178 K in 50 μs was calculated, which is sufficient for the epoxy coating to commence ablation during the steady test period. The 10% temperature penetration depth is 6 μm in 50 μs. The luminosity from substantial portions of the model and shock-layer flow was visualized using a Shimadzu HPV1 high-speed charge-coupled device (CCD) video camera recording at 500 kfps with a 1 μs exposure time. The uniform image response over the axisymmetric model implies the shock-layer gas irradiance is high immediately behind the shock and decreases rapidly as the model surface is approached. The measurements showed that use of an epoxy coating results in greatly increased CN and C2 radiation, much greater than when no coating is employed.