Motor Steerable (MS) assemblies are used globally in the majority of directional drilling applications. However, the limitations of MS systems are often highlighted as well paths become more complicated and efficient drilling performance becomes more difficult to obtain. Tools that impart cyclic, axial oscillations into the drill string have been shown to extend the operating range of MS assemblies, particularly in slide-drilling mode, including coiled tubing applications (Robertson–2004). Adding the correct Axial-oscillation Generator Tool (AGT) to a drill string can dramatically improve slide drilling (Rasheed–2001); and significantly improve work over operations with coiled tubing as well (Tongs–2007). When evaluating the overall performance of a drilling system, it is necessary to determine the interaction between the AGT, Bottom Hole Assembly (BHA) and drill string as a whole. This paper will document the magnitude of the forces generated by the AGT and compare them to the specifications of other common drilling components. It will confirm that the correct selection and configuration of an AGT will impart benign forces into the drilling assembly, improving the effectiveness of the drilling system, and maintaining full compatibility with the entire drill string. Historically, measuring the actual forces transmitted by the AGT has been a challenge, as most downhole measuring devices record at sample rates significantly lower than the operating frequency of the oscillation tool. These recording devices often lack the necessary number of data channels required to fully describe the downhole dynamic environment. Furthermore, variations in bit type, BHA configuration, drilling parameters and formations make evaluating results from different wells difficult. To accurately measure downhole vibration and other drilling parameters, a Drilling Research Tool (DRT) was used. The DRT is a high-speed, sixteen-channel, downhole dynamics recorder. By ensuring identical BHA's, drilling parameters and formations, the differences in downhole activity can be attributed to the axial oscillation system. This paper will compare a number of field runs with and without an AGT and will quantify the actual downhole accelerations caused by adding the oscillation system to the drill string. The results will show that the addition of an effective axial oscillation tool positively influences drilling performance while maintaining compatibility with all drill string components.
No takes yet. Share an insight, caveat, or question.
McCarthy et al. (2009) studied this question.