Key points are not available for this paper at this time.
The effects of the intermetallic compound (IMC) microstructure and the strain rate on the tensile strength and failure mode of Pb-free solder joints are investigated. The samples of Sn3.0Ag0.5Cu/Cu solder joints are aged isothermally at 150 °C for 0, 72, 288 and 500 h, and the thickness of the IMC layer and the roughness of the solder/IMC interface are measured and used to characterize the microstructure evolution of the IMC layer. The tensile tests of the aged solder joints are conducted under the strain rates of 2 × 10−4, 2 × 10−2 and 2 s−1. The results indicate that both the thickness and roughness of the IMC layer have influence on the strength and failure mode of the solder joint. With the increase of the aging time, the thickness of the IMC layer increases and the roughness of the solder/IMC interface decreases, as a result, the tensile strength of the solder joint decreases and the dominant failure mode migrates from the ductile fracture in the bulk solder to the brittle fracture in the IMC layer. There is a positive correlation between the tensile strength of the solder joint and the stain rate applied during the test. With the increase of the strain rate, the failure mode migrates from the ductile fracture in the bulk solder to the brittle fracture in the IMC layer.
An et al. (Mon,) studied this question.