Contact–impact phenomena caused by joint clearances can significantly alter the dynamic response of high-speed mechanical systems, yet fewer studies combine analytical impact-force modeling, virtual prototyping, and experimental observations for multi-cylinder internal combustion engine mechanisms within a unified framework. This problem is scientifically important because the piston–connecting rod–crankshaft chain is subjected to rapid motion reversals, high transmitted loads, and local clearances that may generate shocks, force amplification, and vibration growth. The objective of this study is to evaluate the influence of mechanical impact on the dynamic response of a three-cylinder inline engine mechanism by combining analytical modeling, MSC Adams virtual prototyping, and experimental investigation. The mechanism was analyzed in two operating conditions: under load, using an experimentally derived gas pressure input, and without load at low speed imposed on the crankshaft, using a sectioned engine test bench. The loaded virtual model was studied at a crankshaft speed of 6000 rpm, with cylinder gas pressure peaks above 90 bar and engine torque oscillating around 170 Nm. A radial clearance of 0.03 mm was introduced in the connecting rod–piston joint to evaluate clearance-induced impacts. The results showed that the damping coefficient strongly influences the amplitude and harmonic content of the impact force. For the analyzed no-load case at low speed, the simulated impact force reached a maximum value of 3000 N. Experimentally, the worn connecting rod with 0.03 mm clearance exhibited markedly higher dynamic response than the clearance-free case, with the maximum longitudinal acceleration increasing from 17.77 to 48.26 m/s2 at 1.341 Hz. The novelty of the study lies in the integrated analytical–virtual–experimental investigation of clearance-induced impact in a three-cylinder inline engine mechanism and in the comparative evaluation of its effects on joint forces and vibration signatures. In addition, compared to other models, the novelty lies in introducing and adapting the impact force damping component for mechanisms with rapid motion and high dynamic loads.
Dumitru et al. (2026) studied this question.