Key points are not available for this paper at this time.
The high-reliability requirement of numerical control (NC) machine tools emphasizes the effectiveness of preventive maintenance (PM). However, most existing PM decisions are made by treating them as single-component systems, resulting in the problems of “excessive maintenance” or “insufficient maintenance.” Moreover, real failure data has rarely been utilized for maintenance decision-making, which leads to idealized policies far from practice. This article presents a framework to derive the optimal group maintenance (GM) policy from real failure histories for an NC machine tool comprised of heterogeneous components. Criticality analysis is first conducted to identify high-risk and low-risk components. The lifetime of each high-risk component is characterized by a two-parameter Weibull model or by a Weibull competing-risk model according to whether its failures are independent of the other components. High-risk components with strictly increasing or bathtub-shaped failure rates are selected for PM decision-making. This article introduces a multilevel PM decision-making approach: 1) a repair-replacement model is developed at the component level to derive the optimal PM interval and the maximum number of PM actions; and 2) at the system level, a GM procedure is presented to obtain the optimal PM interval of the system. The failure histories of an NC machine tool with 13 components are used to illustrate the effectiveness of the proposed approach. A maintenance plan is finally made based on optimization results to guide maintenance implementation.
Zheng et al. (Wed,) studied this question.