Cathode Design and Flow Field Optimization in Electrochemical Machining of Square Holes

To improve the forming quality, precision, and machining stability of square hole structures in high-hardness gun steel (PCrNi3MoVA) during electrochemical machining (ECM). A planar cathode bottom design array with liquid holes is innovatively proposed in this paper to achieve uniform distribution of the flow field in discrete bottom machining gaps. The modeling and simulation of the flow field within the ECM gap were carried out using simulation software. A cathode with 25 outlet holes in an array distribution and a profile thickness of 1 mm was designed. However, sparking occurred on the cathode bottom surface during ECM experiments, leading to machining short-circuit. Further analysis and structural optimization were conducted on the sparking area of the cathode bottom surface. The introduction of flow guide grooves on the cathode bottom surface can effectively improve the uniformity of flow field distribution and the stability of the machining process, thereby solving the problem of manufacturing square holes in high-hardness gun steel materials. Finally, under the conditions of an electrolyte pressure of 0.7 MPa, a machining voltage of 12 V, a frequency of 2 kHz, a duty cycle of 60%, and a feed rate of 0.8 mm/min, a square hole with a side length of 10.2 mm was obtained, with a straightness error of ±0.05 mm and a filet radius of 0.38 ± 0.05 mm.