Key points are not available for this paper at this time.
Zeolite materials are widely used as adsorbents in pressure swing adsorption (PSA) technology for hydrogen purification, particularly excelling in removing weakly adsorbed gases such as N 2 and CO. The selection of zeolite materials is crucial for enhancing the performance of hydrogen purification. This study investigates the adsorption capacity , selectivity and working capacity of three widely used zeolite adsorbents (5A, LiX and 13X) and a zeolite-like material (UTSA-16) for hydrogen purification from steam methane reforming off-gas (SMROG), composed of H 2 /CO 2 /CH 4 /CO = 73/16/8/3 mol%. The results indicate that, based on adsorption isotherms , Zeolite LiX exhibits the strongest adsorption capacity for CH 4 and CO. From the perspective of selectivity, LiX demonstrates the highest S (CO2+CH4+CO)/H2 value, making it preliminarily identified as an ideal adsorbent for hydrogen purification. In terms of working capacity, UTSA-16 shows the highest working capacity for CO 2 and CH 4 , making it more suitable for scenarios involving the removal of CO 2 in layered adsorption bed designs, while 13X exhibits the highest working capacity for CO. To further evaluate the dynamic performance of these adsorbents for hydrogen purification, the adsorption, heat and mass transfer model for multi-component gas mixtures was established by Aspen Adsorption software. The simulation results align well with experimental data. In the analysis of the dynamic adsorption characteristics of typical SMROG mixtures, a comparison of the dimensionless breakthrough times ( τ break ) for CO and CH 4 on various adsorbents reveals the following order: LiX >13X > 5A > UTSA-16. Based on this dynamic performance indicator, Zeolite LiX is regarded as the material with the best overall performance among the four adsorbents. By analyzing the equilibrium and dynamic adsorption characteristics in terms of selectivity, working capacity and dynamic breakthrough curve , this study not only elucidates the adsorption behavior of different adsorbents in multi-component gas separations but also provides theoretical insights and practical guidance for optimizing adsorbent selection in PSA systems. • Equilibrium and dynamic adsorption characteristics of zeolites and UTSA-16 were conducted. • LiX has superior adsorption capacity for CH4 and CO and achieved highest selectivity. • UTSA-16 has lowest adsorption capacity for CO and highest working capacity for CO 2 and CH 4 . • Zeolite LiX achieved the longest dimensionless breakthrough time of CH 4 and CO. • Zeolite LiX was considered the promising material for hydrogen purification.
Li et al. (Thu,) studied this question.