A low-power high-psrr current-mode microphone preamplifier

Bionic implants for the deaf require wide-dynamic-range low-power microphone preamplifiers with good wide-band rejection of the supply noise. Widely used low-cost implementations of such preamplifiers typically use the buffered voltage output of an electret capacitor with a built-in JFET source follower. We describe a design in which the JFET microphone buffer's output current, rather than its output voltage, is transduced via a sense-amplifier topology allowing good in-band power-supply rejection. The design employs a low-frequency feedback loop to subtract the dc bias current of the microphone and prevent it from causing saturation. Wide-band power-supply rejection is achieved by integrating a novel filter on all current-source biasing. Our design exhibits 80 dB of dynamic range with less than 5 μV/sub rms/ of input noise while operating from a 2.8 V supply. The power consumption is 96 μW which includes 60 μW for the microphone built-in buffer. The in-band power-supply rejection ratio varies from 50 to 90 dB while out-of-band supply attenuation is greater than 60 dB until 25 MHz. Fabrication was done in a 1.5-μm CMOS process with gain programmability for both microphone and auxiliary channel inputs.