Experimental Investigation on the Influence of Inside-Trapped Water Effect and Remedial Grouting on the Vertical Bearing Characteristics of Suction Bucket Foundations for Offshore Wind Turbines in Sand

This study investigates the influence of inside-trapped water and remedial grouting on the vertical bearing behaviour of suction bucket foundations in sand through 1 g laboratory model tests. The tests were designed to compare the relative responses of different trapped-water and grouting conditions under the same model scale, sand preparation procedure, and loading protocol. Two target trapped-water conditions were considered: a condition without an observable continuous water layer beneath the bucket lid and a condition with an initial trapped-water thickness of approximately 2 cm. These conditions were controlled and verified before loading using the scale attached to the transparent bucket wall and the underwater camera monitoring system. The results show that inside-trapped water modifies the vertical load-transfer path between the bucket lid and the internal soil plug. When a water layer exists beneath the lid, direct lid–soil plug contact is weakened, and the foundation resistance relies more strongly on skirt-side resistance and the resistance mobilized near the bucket rim. Under cyclic vertical loading, the trapped-water case exhibited larger cumulative displacement and a lower post-cyclic bearing response than the no-trapped-water case. The secant cyclic stiffness showed a continuous increase in the no-trapped-water case, whereas a rise-then-fall trend was observed in the trapped-water case, which may be associated with cyclic densification, soil plug disturbance, changes in lid–soil plug contact, and possible local pore pressure development. Remedial grouting filled the trapped-water space beneath the bucket lid and partially restored the lid–soil plug load-transfer path. Under the present model test conditions, the post-cyclic dimensionless bearing capacity of the grouted cases increased by approximately 13–16% relative to the ungrouted trapped-water case. The grouting cases with different bentonite contents showed similar recovery trends within the limited dataset, suggesting that the improvement was mainly related to filling and sealing the trapped-water space rather than to the intrinsic strength of the grout material.