Key points are not available for this paper at this time.
In response to the growing demand for alternatives to traditional stirrups in construction, discrete fibers have emerged as a promising solution, offering potential time savings during the building process. Among these, the use of recycled plastic fibers has garnered significant attention, addressing both environmental sustainability and material efficiency challenges in the construction industry. This research focuses on incorporating recycled plastic as discrete fibers within concrete beams reinforced with basalt fiber-reinforced polymer (BFRP) bars, with the dual objectives of reducing environmental impact and enhancing construction efficiency. This research investigates the shear behavior and strength of concrete beams reinforced with BFRP bars through both experimental and numerical methods. Three types of discrete fibers (straps, water bottles, and ropes) were examined for their influence on beam performance. The study focuses on two key parameters: the aspect ratio of the fibers and the different materials from which they are made. Seven concrete beams were tested experimentally to assess these effects, and the experimental findings were further validated using finite element analysis FEM by using ABAQUS. The experimental results indicated that recycled plastic fibers did not significantly enhance the shear strength of FRC beams, with the exception of the BFRP-reinforced beam containing 20 mm short water bottle fibers, which showed a 13.97 % improvement in shear strength compared to the control beam. Furthermore, the analytical results aligned well with the experimental findings in terms of failure load, cracking behavior, and deformation behavior, demonstrating strong consistency between the two approaches. • Dual objective of reducing environmental impact and enhancing construction efficiency. • Recycled plastic fibers in RC beams reinforced with BFRP bars enhance performance. • Experimental study of the shear behavior and strength of three types of fibers. • Validation through Finite Element simulation including plasticity and damage models.
Hassan et al. (Wed,) studied this question.