Key points are not available for this paper at this time.
Hydrogels are very popular in biomedical areas for their extraordinary biocompatibility. However, most bio-hydrogels are too brittle to perform micro/nanofabrication. An effective method is cast molding; yet during this process, many defects occur as the excessive demolding stress damages the brittle hydrogels. Here, we propose a brand-new damage-free demolding method and a soft ultrafine fiber mold (SUFM) to replace the traditional mold. Both mechanical and finite element analysis (FEA) reveal that SUFMs have obvious advantages especially when the contact area between hydrogel and mold gets larger. By means of a high-resolution 3D printing called electrohydrodynamic (EHD) printing, SUFMs with various topological structures can be achieved with the fiber diameter ranging from 500 nm to 100 μm, at a low cost. Microfluidics and cell patterns are implemented as the demonstration for potential applications. Owing to the tiny scale of microstructures and the hydrophilicity of hydrogels, significant capillary effect occurs which can be utilized to deliver liquid and cells autonomously and to seed cells into those ultrafine channels evenly. The results open up a new avenue for a wider use of hydrogels in biomedical devices, tissue engineering, hydrogel-based microfluidics and wearable electronics; the proposed fabrication method also has the potential to become a universal technique for micro/nanofabrication of brittle materials.
Lv et al. (Thu,) studied this question.