Experimental Evaluation of the Flexural and Bearing Mechanical Properties of Dragonwood in Jacking Applications in Comparison to Ekki

Engineered bamboo composites (EBCs) are increasingly considered as sustainable alternatives to tropical hardwoods in structural applications. In jacking systems, performance is primarily governed by compression perpendicular-to-grain (bearing), although improper use may introduce flexural demands. This study evaluates the bearing and flexural behavior of Dragonwood, a commercial parallel strand bamboo (PSB), in comparison to Ekki (Lophira alata) through 120 full-scale tests. Dragonwood exhibited higher mean bearing capacity than Ekki, with yield stresses exceeding those of Ekki by over 60%, indicating strong potential for bearing-dominated applications such as in jacking. However, face-bonded specimens showed sensitivity to glue-line orientation, resulting in flexural strength reductions of up to 42% and undesirable shear failures. Increasing adhesive content and pressing pressure in the manufacturing process did not eliminate this behavior. Single-lift specimens removed the glue-line and showed improved failure behavior in flexure, although with reduced strength. The results demonstrate that manufacturing strategy heavily influences PSB performance. While single-lift Dragonwood products show the most potential, further testing under bearing is required before its suitability for jacking applications can be fully established.