Key points are not available for this paper at this time.
Abstract This study fixates on determining the optimum laser input parameters that simultaneously meet the desired kerf width and depth during CO2 laser cutting of various polymethylmethacrylate (PMMA) sheets. It has three contributions. The first is to model the cutting process of PMMA by polynomial curve fitting as a function of laser power, laser speed, and standoff distance. R-squared (R 2 ), adjusted R 2 and root-mean-square error (RMSE) criteria were taken into account to measure the performance of the proposed model. The effect of laser parameters on the process is investigated by analysis of variance (ANOVA) and sensitivity analysis. The second is to optimize the derived nonlinear regression models using genetic algorithm (GA), particle swarm optimization (PSO), whale optimization algorithm (WOA) and ant lion optimization (ALO) metaheuristic methods and compare the performances of the algorithms. The third is to compare the adequacy of the optimization process with the artificial neural network (ANN). The investigations exhibited that the best-fitting polynomials are obtained with the R 2 and adjusted R 2 values of over 99% and 97%, respectively. ANOVA and sensitivity test revealed that the sensitivity of the laser power, which is the most effective parameter, was 150 at low powers and decreased to 0 as the power value increased. When the nozzle distance is 4.1, the proposed metaheuristics gave effective and sufficiently accurate results. PSO stood out in terms of both best cost value (3.49 × 10 –8 ) and relative error value (0.19%). The relative error of the ANN was found as 3% in terms of kerf depth.
Ürgün et al. (Thu,) studied this question.