Key points are not available for this paper at this time.
In this study, cellulose was extracted from giant cane (GC), Posidonia oceanica seagrass (PO), coffee silverskin (CS), and brewer's spent grain (BSG) as alternatives to conventional sources of cellulose. The extraction protocol involved three steps: i) hemicellulose and lignin removal through alkaline hydrolysis in a 5% (w/v) NaOH solution (solid-to-liquid ratio = 1:100 g/mL, T = 25 °C, t = 2 h, ω = 300 rpm), ii) removal of organic compounds and ashes through a 95% (v/v) ethanol solution (solid-to-liquid ratio = 1:25 g/mL, T = 25 °C, t = 0.5 h, ω = 500 rpm), and iii) double bleaching in a 1% (w/v) acidic (pH = 4) NaClO 2 solution (solid-to-liquid ratio = 1:50 g/mL, T = 90 °C, t = 1.5 h, ω = 500 rpm). Yield, purity, crystallinity degree, and morphology of cellulose extracted through a soft-chemical cascade process were assessed by gravimetric, infrared (FT-IR), nuclear magnetic resonance (NMR) spectroscopy, X-ray diffraction (XRD), and scanning electron microscopy (SEM) analyses. Averaged cellulose extraction yields of 36.4, 38.6, 23.1, and 22.2% for GC, PO, CS, and BSG were obtained, respectively. All cellulose samples had high purity, though lower than the ultra-pure bacterial cellulose, which was due to the slight contamination from unremoved hemicellulose and lignin residues. Cellulose samples exhibited similar chemical features and the typical fibril-like morphology of microcrystalline cellulose (6–13 μm in width). The versatility of the proposed extraction procedure supports the sustainable conversion of low-cost organic biomasses to valuable products with manifold industrial applications (e.g., food packaging). • Four different lignocellulosic biomasses were selected for cellulose extraction. • Cellulose samples showed a comparable purity to that of bacterial cellulose. • The higher crystallinity was found for cellulose from giant cane. • A fibril-like morphology of achieved celluloses was observed.
Bellesia et al. (Thu,) studied this question.