Key points are not available for this paper at this time.
Capillary forces were shown to influence the distribution of polymer‐plasicizer mixtures within ceramic green bodies during binder thermolysis. Isothermal thermogravimetric analysis was performed on tape‐cast sheets of an aluminapoly(vinyl butyrall‐dibutyl phthalate composite and direct observations were made of the binder distribution and pore growth after partial pyrolysis. This led to the investigation of a model system, an alumina‐eicosane composite, by similar experimental techniques. The early stage of binder removal was found to be similar to the drying of particle beds in which capillary forces draw liquid into the smaller pores at the surface. The morphology of the binder distribution produced by these processes dictates which mass‐transfer resistances may be controlling in binder burnout. A model is described that determines the length scale over which capillarity acts based on measurable physical parameters of the binder system and the packing of the ceramic particles.
Cima et al. (Sat,) studied this question.