Key points are not available for this paper at this time.
Climate change is increasing the severity and length of heat waves. Heat stress limits crop productivity and can make plants more sensitive to other biotic and abiotic stresses. New methods for managing heat stress are needed. Herein, we have developed ∼30 nm diameter poly(acrylic acid)-block-poly(N-isopropylacrylamide) (PAA-b-PNIPAm) star polymers with varying block ratios for temperature-programmed release of a model antimicrobial agent (crystal violet, CV) at plant-relevant pH. Hyperspectral-Enhanced Dark field Microscopy was used to investigate star polymer–leaf interactions and route of entrance. The majority of loaded star polymers entered plant leaves through cuticular and epidermis penetration when applied with the adjuvant Silwet L-77. Up to 43 wt % of star polymers (20 μL at 200 mg L–1 polymer concentration) applied onto tomato (Solanum lycopersicum) leaves translocated to other plant compartments (younger and older shoots, stem, and root) over 3 days. Without Silwet L-77, the star polymers penetrated the cuticle, but mainly accumulated at the epidermis cell layer. The degree of the star polymer temperature responsiveness for CV release in vitro in the range of 20 to 40 °C depends on pH and the ratio of the PAA to PNIPAm blocks. Temperature-responsive release of CV was also observed in vivo in tomato leaves. These results underline the potential for PAA-b-PNIPAm star polymers to provide efficient and temperature-programmed delivery of cationic agrochemicals into plants for protection against heat stress.
Zhang et al. (Mon,) studied this question.