Key points are not available for this paper at this time.
Binary mixtures of HFE-73DE and ethyl acetate are investigated as dielectric working fluids for laminar minichannel cooling. Thermophysical properties of the pure components and four mixtures (10/90, 25/75, 50/50 and 75/25 mass % HFE-73DE/ethyl acetate) were measured over the relevant temperature range. Single-phase convective heat transfer tests were then carried out in a heated 1 × 4 × 180 mm minichannel test section under constant heat-flux conditions for pure HFE-73DE. A three-dimensional conjugate CFD model with temperature-dependent liquid properties was developed in Simcenter STAR-CCM+ and validated against these measurements; the average relative temperature difference between CFD and experiment remained below 0.5%, while a grid-convergence study based on the Grid Convergence Index (GCI) confirmed that the numerical uncertainty is comparable to the experimental one. The validated model was subsequently used to predict the axial evolution of wall temperature, fluid-core temperature, velocity and heat transfer coefficient for the four mixtures under identical conditions. The mean Nusselt numbers obtained from CFD were further compared with the classical Shah and London fully developed laminar solution for rectangular ducts, revealing that the present configuration yields values about 35–42% higher than the theoretical prediction owing to asymmetric heating and conjugate heat transfer. The results show that increasing the HFE-73DE mass fraction strengthens convective heat transfer and reduces fluid-temperature rise, while intermediate compositions (50/50 and 75/25) provide a favourable compromise between enhanced heat transfer performance and moderate pressure drop. The study provides guidance for composition selection and the design of dielectric minichannel heat exchangers operating with HFE-73DE/ethyl acetate mixtures.
Piasecki et al. (Thu,) studied this question.