Thermal effects of a combined irrigation method during implant site drilling. A standardized in vitro study using a bovine rib model

OBJECTIVES: The purpose of this study was to evaluate the temperature changes during implant osteotomies with a combined irrigation system as compared to the commonly used external and internal irrigation under standardized conditions. MATERIAL AND METHODS: Drilling procedures were performed on VII bovine ribs using a computer-aided surgical system that ensured automated intermittent drilling cycles to simulate clinical conditions. A total of 320 drilling osteotomies were performed with twist (2 mm) and conical implant drills (3.5/4.3/5 mm) at various drilling depths (10/16 mm) and with different saline irrigation (50 ml/min) methods (without/external/internal/combined). Temperature changes were recorded in real time by two custom-built thermoprobes with 14 temperature sensors (7 sensors/thermoprobe) at defined measuring depths. RESULTS: The highest temperature increase during osteotomies was observed without any coolant irrigation (median, 8.01°C), followed by commonly used external saline irrigation (median, 2.60°C), combined irrigation (median, 1.51°C) and ultimately with internal saline irrigation (median, 1.48°C). Temperature increase with different drill diameters showed significant differences (P < 0.05) regarding drill depth, confirming drill depth and time of drilling as influencing factors of heat generation. Internal saline irrigation showed a significantly smaller temperature increase (P < 0.05) compared with combined and external irrigation. A combined irrigation procedure appears to be preferable (P < 0.05) to an external irrigation method primarily with higher osteotomy depths. CONCLUSIONS: Combined irrigation provides sufficient reduction in temperature changes during drilling, and it may be more beneficial in deeper site osteotomies. Further studies to optimize the effects of a combined irrigation are needed.