Influence of surface roughness features on mixed‐film lubrication

An optical technique (three‐dimensional spacer layer imaging) has been developed to map accurately lubricant film thickness in thin‐film elastohydrodynamic (EHD) contacts. This experimental technique has been used to study the influence of surface roughness features, asperity height, and slope on EHD film thickness and pressure. Single ridges transverse to the entrainment direction were used to represent asperities. It was found that the ridges with lower slopes generate films of greater minimum thickness. Below a certain entrainment speed, the minimum film thickness declined at a rate dependent on the ridge slope. At low speeds, the ridges with higher slopes entrapped a larger volume of lubricant ahead of the ridge and along the entrainment direction. For all speeds, the highest ridges entrapped the most lubricant. Both ridge slope and ridge height had a negligible effect on mean film thickness in the contact. Asperity pressure increased with higher ridge slope, but was not influenced by entrainment speed. An increase in pressure was found where lubricant is entrapped upstream of a ridge.