Physico‐chemical characteristics of palm‐based oil blends for the production of reduced fat spreads

The effect of blending and interesterification on the physicochemical characteristics of fat blends containing palm oil products was studied. The characteristics of the palm‐based blends were tailored to resemble oil blends extracted from commercial reduced fat spreads (RFS). The commercial products were found to contain up to 20.4% trans fatty acids, whereas the palm‐based blends were free of trans fatty acids. Slip melting point of the blends varied from 26.0–32.0°C for tub, and 30.0–33.0°C for block RFS. Solid fat content at 5 and 10°C (refrigeration temperature), respectively, varied from 10.9–19.7% and 8.5–17.6% for tub, and 28.2–38.6% and 20.8–33.5% for block RFS. Melting enthalpy of the tub RFS varied from 35.0–54.3 J/g and that of block RFS varied from 58.0–75.4 J/g. To produce block RFS, 65% palm oil (PO) and 18% palm kernel olein (PKOo) could be added in a ternary blend with sunflower oil (SFO), but only 47% PO and 10% PKOo are suggested for tub RFS. Higher proportion of PO, i.e., 72% for block RFS and 65% for tub RFS, could be used after the ternary blend was interesterified. Although a ternary blend of palm olein (POo)/SFO/PKOo was not suitable for RFS formulation, after interesterification as much as 90% POo and 26% PKOo could be used in the block RFS formulation. For tub RFS a maximum of 30% POo was found suitable.