Analysis and elimination of hysteresis and noisy precursors in power amplifiers

Power amplifiers (PAs) often exhibit instabilities leading to frequency division by two or oscillations at incommensurate frequencies. This undesired behavior can be detected through a large-signal stability analysis of the solution. However, other commonly observed phenomena are still difficult to predict and eliminate. In this paper, the anomalous behavior observed in a Class-E PA is analyzed in detail. It involves hysteresis in the power-transfer curve, oscillation, and noisy precursors. The precursors are pronounced bumps in the power spectrum due to noise amplification under a small stability margin. The correction of the amplifier performance has required the development of a new technique for the elimination of the hysteresis. Instead of a trial-and-error procedure, this technique, of general application to circuit design, makes use of bifurcation concepts to suppress the hysteresis phenomenon through a single simulation on harmonic-balance software. Another objective has been the investigation of the circuit characteristics that make the noisy precursors observable in practical circuits and a technique has been derived for their elimination from the amplifier output spectrum. All the different techniques have been experimentally validated.