Some estimates of the surface tension of curved surfaces using density functional theory

Density functional theory is used to calculate the surface tension of planar and slightly curved surfaces, which can be written as gamma(R)=gamma(infinity)(1-2delta(infinity)R), where R is the radius of curvature of the surface. Calculations are performed for a Lennard-Jones fluid, split into a hard-sphere repulsive potential and an attractive part. The repulsive part is treated using the local density approximation. The attractive part is treated using a high temperature approximation (HTA) in which the pair correlation function is approximated by the Percus-Yevick pair correlation function of a uniform hard-sphere fluid evaluated at a position-dependent average density. An expression relating the Tolman length delta(infinity) to the density profile of the planar surface is derived. Numerical results are presented for the planar surface tension gamma(infinity) and for delta(infinity) and are compared with those using mean field theory (MFT) and with those using the square-gradient approximation. Values for gamma(infinity) using the HTA are 30%-40% higher than those using MFT. Values for delta(infinity) using the HTA are around -0.1 (in units of the Lennard-Jones parameter sigma) and only weakly dependent on temperature. These values are less negative than the values from MFT. The square-gradient approximation gives reasonable estimates of the more accurate nonlocal results for both the MFT and the HTA.