Morphology and properties of layered silicate‐polyethylene nanocomposite blown films

Film grade ethylene vinyl acetate (EVA), low density polyethylene (LDPE), and high density polyethylene (HDPE) were melt compounded with an organically modified montmorillonite, then blown into films. The morphology studies showed that all three types of film involve intercalated clay particles. The dependence of intercalation extent on the matrix as well as on the molecular weight of compatibilizers is discussed. The tensile testing data showed that the clay enhancing effects apply mainly to the modulus, instead of to the strength. The EVA‐based nanocomposite films exhibit the most significantly improved modulus while the HDPE‐based films have the least. Lower molecular weight compatibilizers could promote the clay enhancing effects while higher molecular weight compatibilizers could increase the matrix properties. Steady shear viscosities of an intercalated and an exfoliated system were also investigated. Comparing our data with that from the literature lead us to conclude that: 1) the zero‐shear viscosity of a nanocomposite is mainly determined by clay loading instead of by clay intercalation/exfoliation structures and the matrix viscosity; and 2) the clay orientation during a shear flow is highly dependent on the matrix flow behavior and to a lesser extent on the clay structural state. POLYM. ENG. SCI., 45:469–477, 2005.