Effect of Loading Mode and Coating on Dynamic Fatigue of Optical Fiber in Two‐Point Bending

Two‐point bending is a useful method for investigating the mechanical properties of optical fiber and has several advantages when compared to the traditional tensile test. However, the strength of the fiber is usually determined at constant faceplate velocity rather than at constant strain rate as in the uniaxial tensile test, and previous work casts doubt on the comparability of fatigue results obtained using different loading modes and hence on the reliability of the bending technique. This paper presents dynamic fatigue results using a two‐point bend apparatus that can be programmed to operate in constant velocity, constant strain rate, and constant stress rate loading modes. These results, obtained for both bare and polymer‐coated fused silica optical fiber, show no significant differences in the calculated fatigue parameters for the three loading modes and clearly indicate the reliability of the two‐point bend method at constant faceplate velocity. The results, however, show that the obtained value of the stress corrosion susceptibility parameter, n , is dependent on the quantity used to define it, i.e., stress or strain to failure, because of the nonlinear elastic behavior of silica.