Chemical Effects of Tin Oxide Nanoparticles in Polymer Electrolytes-Based Dye-Sensitized Solar Cells

The effects on the photovoltaic performance of the incorporation of SnO 2 nanoparticles into the polymer of a solid-state dye-sensitized solar cell (DSC) based on the poly(ethylene oxide)/poly(ethylene glycol) dimethyl ether solid electrolyte are studied in this paper. It has been found that the addition of SnO 2 nanoparticles to the solid electrolyte produces several key changes in the properties of the solid-state DSC that produced a better performance of the device. Therefore, we have measured an improvement in electrolyte conductivity by a factor of 2, a linear rise in the TiO 2 conduction band position, a reduction in the electron recombination rate, and a decrease in charge-transfer resistance at the counterlectrode/electrolyte interface. All these improvements produced an increase in the power conversion efficiency from 4.5 to 5.3% at 1 sun condition, a consequence of the increase of both V oc (oc = open circuit) and J sc (sc = short circuit) without any sacrifice in FF (fill factor) . The origin of these changes has been associated to the strong Lewis acidic character of SnO 2 nanoparticles yielding to the formation of a I 3 – percolation layer for holes at the surface of SnO 2 and the reduction of the concentration of free I 3 – and K + ions inside the pores of TiO 2 . From these results, it is concluded that the physicochemical effects of inorganic nanofiller in the polymer electrolyte may also be considered a good route in designing the high efficiency solid-state DSCs employing the polymer electrolyte.