The presence of mining-related cavities (workings, shafts and tunnels) or karstic (solution cavities and sinkholes in limestone) within the top 100 m in the rock mass restricts land utilisation, and their migration to the surface may damage property or services or cause loss of life. Confirmation of features marked on existing plans prior to design and construction may be sufficient but it is often necessary to determine the detailed sub-surface structure. The standard method of site investigation is to drill a pattern of boreholes to locate the spatial extent of any cavities. However, unless the spacing is less than the cavity dimensions it is possible to miss it completely. A cavity may be filled with air, water, or collapse material resulting in a contrast in physical properties which may be detected using appropriate geophysical methods. One powerful technique is microgravity which locates areas of contrasting sub-surface density from surface measurements of the earth’s gravity. Although the method is fundamentally simple, measurement of the minute variations in gravity (1 in 10 8 ) requires sensitive instruments, careful data acquisition, and data reduction and digital data analysis. Final interpretation must be performed in conjunction with independent information about the site’s history and geology. This paper presents three examples in both mining and karstic environments demonstrating that microgravity is a very effective technique for detecting and delineating cavities in the sub-surface.
No takes yet. Share an insight, caveat, or question.
Bishop et al. (1997) studied this question.