Knowledge of process-structure-property relationships to engineer better heat treatments for laser powder bed fusion additive manufactured Inconel 718

Dislocation structures, chemical segregation, γ′, γ″, δ precipitates, and Laves phase were quantified within the microstructures of Inconel 718 (IN718) produced by laser powder bed fusion additive manufacturing (AM) and subjected to standard, direct aging, and modified multi-step heat treatments. Additionally, heat-treated samples still attached to the build plates vs. those removed were also documented for a standard heat treatment. The effects of the different resulting microstructures on room temperature strengths and elongations to failure are revealed. Knowledge derived from these process-structure-property relationships was used to engineer a super-solvus solution anneal at 1020 °C for 15 min, followed by aging at 720 °C for 24 h heat treatment for AM-IN718 that eliminates Laves and δ phases, preserves AM-specific dislocation cells that are shown to be stabilized by MC carbide particles, and precipitates dense γ′ and γ″ nanoparticle populations. This “optimized for AM-IN718 heat treatment” results in superior properties relative to wrought/additively manufactured, then industry-standard heat treated IN718: relative increases of 7/10 % in yield strength, 2/7 % in ultimate strength, and 23/57 % in elongation to failure are realized, respectively, regardless of as-printed vs. machined surface finishes.