A finite element simulation-based method optimized polymeric injection patterns in the left ventricle, yielding a 3x6 inclusion pattern when balancing myofiber stress and stroke volume.
A finite element simulation method can automatically optimize polymeric injection patterns in the failing left ventricle to balance myofiber stress reduction and stroke volume preservation.
Heart failure continues to present a significant medical and economic burden throughout the developed world. Novel treatments involving the injection of polymeric materials into the myocardium of the failing left ventricle (LV) are currently being developed, which may reduce elevated myofiber stresses during the cardiac cycle and act to retard the progression of heart failure. A finite element (FE) simulation-based method was developed in this study that can automatically optimize the injection pattern of the polymeric "inclusions" according to a specific objective function, using commercially available software tools. The FE preprocessor TRUEGRID((R)) was used to create a parametric axisymmetric LV mesh matched to experimentally measured end-diastole and end-systole metrics from dogs with coronary microembolization-induced heart failure. Passive and active myocardial material properties were defined by a pseudo-elastic-strain energy function and a time-varying elastance model of active contraction, respectively, that were implemented in the FE software LS-DYNA. The companion optimization software LS-OPT was used to communicate directly with TRUEGRID((R)) to determine FE model parameters, such as defining the injection pattern and inclusion characteristics. The optimization resulted in an intuitive optimal injection pattern (i.e., the one with the greatest number of inclusions) when the objective function was weighted to minimize mean end-diastolic and end-systolic myofiber stress and ignore LV stroke volume. In contrast, the optimization resulted in a nonintuitive optimal pattern (i.e., 3 inclusions longitudinallyx6 inclusions circumferentially) when both myofiber stress and stroke volume were incorporated into the objective function with different weights.
Wenk et al. (Fri,) conducted a other in Heart failure. Polymeric injection patterns (computational optimization) was evaluated on Optimal injection pattern based on objective functions. A finite element simulation-based method optimized polymeric injection patterns in the left ventricle, yielding a 3x6 inclusion pattern when balancing myofiber stress and stroke volume.