Key points are not available for this paper at this time.
A lidar technique has been proposed and demonstrated for remotely sensing particulate beam attenuation coefficient (cp) profiles using the Raman backscattered signal from water. In Raman lidar, the backscatter coefficient at 180° can be considered constant, allowing for the determination of the lidar attenuation coefficient (Klidar) from the Raman backscattered signal. This scheme has these features. 1) The bandwidth of the filter that used to extract the Raman component from the backscattered signal of the lidar was optimized to ensure sufficient lidar signal strength while minimizing the influence of chlorophyll fluorescence on inversion. 2) A receiving telescope with narrow field of view (FOV) and small aperture was utilized to suppress multi-scattering components in the backscattered signal. 3) A relationship between the beam attenuation coefficient (c) and Klidar was established after simulations via a semi-analytic Monto Carlo. 4) The value of cp was obtained by subtracting the attenuation coefficient of pure seawater (cw) from c. According to the theoretical analysis, the maximum relative error of cp is less than 15% for chlorophyll concentrations up to 10 mg/m3. Due to the water Raman backscattered signal being several orders of magnitude lower than the elastic backscattered signal, a single-photon detector is required to significantly improve the detection sensitivity to the single-photon level. To validate this approach, a field experiment was conducted aboard the R/V Tan Kah Kee in the South China Sea from September 4th to September 5th, 2022, and continuous subsurface profiles of cp were obtained. These measurements confirm the robustness and reliability of the oceanic single-photon Raman lidar system and the inversion method.
Shangguan et al. (Fri,) studied this question.