Continuous Heterogeneous Fenton for Swine Wastewater Treatment: Converting an Industry Waste into a Wastewater Treatment Material

Swine wastewater (SW) was treated using industrial wastes as raw materials in a pre-treatment process (coagulation or adsorption), followed by a continuous heterogeneous Fenton reaction. Before the treatment conducted as a continuous operation, two different batch optimization strategies were evaluated, in which the effects of H2O2 concentration and pH were studied. The results show that using excessive H2O2 results in the same behavior, regardless of whether the pH is 3 or 7.5, while at low H2O2 concentrations, the acidic pH improves the chemical oxygen demand (COD) removal due to a higher solubility of iron. The partial addition of H2O2 after 60 min of the reaction proved to be unbeneficial. Considering other perspectives, a continuous Fenton process using iron filings (IF) as the iron source (H2O2 = 50 mg/L) was applied after the SW pre-treatment, consisting of adsorption with red mud (RM) or coagulation with poly-diallyldimethylammonium chloride (PDADMAC). The RM adsorption presented higher COD removal and lower toxicity than the PDADMAC coagulation, revealing to be a suitable material for this purpose, but for both pre-treatments, the application of a subsequent continuous Fenton process revealed to be essential to achieve the COD discharge limits imposed by the Portuguese law. In addition, high amounts of dissolved iron were present in the samples (55–58 mg/L) after the Fenton process. However, after the overall treatment, the samples showed no harmful characteristics for Lepidium sativum, being classified as “non-toxic”, contrary to the initial wastewater.