What type of study is this?

This is a Experimental Study study.

October 2, 2025

Synthesis of Biodiesel from Waste Cooking Oil by Using Seashells as Catalyst

Key Points

Biodiesel yield reached 97% using seashell-derived CaO catalyst at 800°C during transesterification processes.
Key metrics included catalyst density of 0.850 g/cm³ and a flash point of 165°C, showing refined oil characteristics.
The heterogeneous catalyst from calcined seashells indicated significant surface area improvements, measured by BET analysis at 76.1888 m²/g.
X-ray diffraction data confirmed the transformation of CaCO3 into CaO, enhancing catalytic activity for future biodiesel production.

Abstract

The basic aim of this research is to study the suitable conditions of the biodiesel by using waste refined cooking oil as a preliminary material with heat-treated seashells at 500and#176;C, 800and#176;C, and 1000and#176;C as heterogeneous catalysts. It recorded at 800 and#176;C a high level of CaO as catalyst 90.89 % under the following reaction conditions: catalyst is 0.5 g, temperature at 80 and#176;C, reaction duration is 180 minutes, and the oil-to-alcohol ratio is 10:20%. The impact of energizing temperature on transesterification processes in the range of 500and#176;C–1000and#176;C proved that the calcination temperature at 800 and#176;C of seashell-derived material raised biodiesel to 97% due to active sites on catalyst surfaces, converting rate linearly in comparison to other catalysts, and this tends to reduce the cost of purification procedures of biodiesel. It has been proved that the catalyst at 800and#176;C possesses a density at 40and#176;C of 0.850 g /cm3, an acid value of 0.6 mg KOH/g oil, a viscosity of 4.9 mm2/s, and a flash point of 165and#176;C. It also contains high catalytic activity in the transesterification process of wasted cooking oil (WCO) for optimizing biodiesel characteristics in the future. As a result, the catalyst demonstrated high action in the transesterification effect. Scanning Electron Microscopy (SEM) illustrates calcined waste shells are irregular in shape, which means small, minute grains of pores accumulate, providing a large area of surface. Furthermore, the physical characteristics of CaO catalysts at 800 and#176;C showed Brunauer- Emmett-Teller (BET) a significant surface area of 76.1888 m2/g and pore volume of 2.6539 cm3/g is considerably greater than other catalysts at temperatures of 500 and#176;C–1000 and#176;C. X-ray diffraction (XRD) data analysis demonstrate the main constituent of seashells is CaCO3, indicated by the diffraction peak at 2and#120579; approximately 28.48∘. However, carbon dioxide CO2 changes when the calcination temperature at 800 and#176;C it transforms CaCO3 completely into CaO, which is the main component of the calcined catalyst. The CaO catalystand#39;s well-crystallized structure is defined by the narrow, high-intensity peaks of catalyst. Eventually, the heterogeneous catalyst led to a significant rise in the active sites.

KI fragen

Bookmark