In the process of using the freezing method to uncover coal from stone gates, the thermal evolution profiles of the coal body during the freezing process tend to be complex due to the presence of gas and moisture. To investigate the temperature response of coal containing gas under different freezing temperature conditions, a self-developed low-temperature freezing test system for coal containing water and gas was used to conduct freezing and cooling tests at different freezing temperatures (−5 °C to −30 °C). The temperature changes at various measuring points inside the coal over time were monitored in real time, and the temperature distribution, cooling law, and strain evolution process of the coal in the axial and radial directions were analyzed. The experimental results show that the cooling process of the center point of the coal can be divided into four stages: rapid cooling, extremely slow temperature drop, relatively slow cooling, and stable constant temperature. The time required to reach the stable constant temperature stage is inversely proportional to the freezing temperature, and corresponding prediction formulas have been established based on this. The standardized coal briquettes exhibit a gradient distribution characteristic of gradually increasing temperature from outside to inside in both axial and radial directions, with the radial temperature distribution being well matched by an exponential decay model. The strain of coal is affected by both thermal shrinkage and ice-induced expansion. The occurrence time of frost heave is positively correlated with freezing temperature, while the strain of frost heave is negatively correlated with freezing temperature. The axial frost heave effect is significantly stronger than the radial effect, but the radial frost heave occurs slightly earlier than the axial effect. This study reveals the thermal-mechanical coupling response mechanism of gas-containing coal during the low-temperature freezing process, and the research results can provide theoretical support for parameter optimization and engineering application of low-temperature freezing anti-outburst technology.
Wang et al. (Thu,) studied this question.