The traditional Discrete Element Method (DEM) can track the motion details of individual particles, but its computational cost becomes excessively high when simulating large-scale systems involving millions or even billions of particles. In this study, a coarse-grained DEM approach was employed to analyze the flow behavior of mixed particles in a coal powder silo. This method maintains reasonable simulation accuracy while effectively reducing the total number of computational particles and significantly improving computational efficiency. After conducting investigations on the mesh-to-particle size ratio and model validation, this paper focuses on examining the effects of coal particle size distribution and mixing ratio on the characteristics of particle motion. The results indicate that during the discharge process of mixed particles, the downward velocity of particles in the central axis region near the outlet is significantly higher than that in the wall region, exhibiting typical funnel flow characteristics. The particle size distribution has a notable impact on the particle descent velocity. The uniform distribution case shows the highest descent velocity, the linear distribution case the lowest, while the normal distribution case falls between the two. Notably, in the normal distribution case, the descent velocity in the central axis region is similar to that of the uniform distribution, while the descent velocity in the wall region approaches that of the linear distribution. This presents a combined characteristic of the two extreme distributions rather than a simple transitional state. In contrast, the particle mixing ratio has a relatively minor influence on the overall motion characteristics. The mass flow rate of particles and the cross-sectional velocity distribution remain largely consistent, with only slight differences observed in the velocity within the central axis region.
Zhang et al. (Wed,) studied this question.