Evaluation of tensile properties on glass/carbon fiber epoxy pure, interply, and locally nested intraply hybrid composites

Abstract In this study, the behavior of pure glass fiber/epoxy, pure carbon fiber/epoxy, interply hybrid, and locally nested intraply hybrid composites under tensile load was investigated. The specimens were produced by the vacuum‐assisted resin transfer molding (VARTM) method. Interply hybrid composites showed approximately the average tensile strength of the glass and carbon fiber/epoxy composites, with 603 MPa. Intraply hybrid composites had 17% lower tensile strength than pure glass fiber/epoxy composites due to the discontinuity of the fibers in the structure. Therefore, pure or interply hybrid composites are suitable in cases where tensile strength is more important, while in special cases where different properties are desired in different regions of a monolithic structure, locally nested intraply hybrid composites can be used. While the finite element analysis (FEA) results of pure and interply hybrid composites were very close to the tensile test, the amount of deviation increased in intraply hybrid composites due to fiber discontinuity. Fiber and void volume fractions of hybrid specimens were found to be around 62% and 1.45%, respectively. The numerical and experimental results of pure carbon fiber/epoxy composite are validated by the analytical solution.