Surface roughness of woven fabrics plays a key role in tactile comfort and skin–textile interaction, particularly in medical applications involving prolonged contact with human skin. This study focuses on the surface roughness of woven fabrics in plain and twill (1/3 S) weaves intended for hospital bed sheets and bedding applications. Plain weave represents a structurally symmetric system, while twill weave exhibits a pronounced diagonal structure. Roughness was evaluated using the Fabric Touch Tester (FTT) and further analyzed through amplitude (Rq), height distribution (Rku), and frequency-related parameters (linear peak density) obtained by signal processing and peak analysis in OriginPro 2026. The results showed that weave structure is the dominant factor influencing surface topography. Plain weave fabrics exhibited higher amplitude roughness and more uniform height distribution, while twill fabrics showed lower global roughness but stronger directional dependence, particularly in diagonal directions. Linear peak density was not significantly affected by laundering cycles, fiber composition, or finishing, but was strongly dependent on weave type. The findings demonstrate that due to the orthotropic nature of woven fabrics, surface roughness, derived from surface topography, cannot be adequately described by a single parameter, and that a combined analysis of amplitude and spatial descriptors is required, with the surface being evaluated not only along the principal symmetry directions (warp and weft) but also in off-axis directions. These results provide valuable insight for the design of hospital textiles with improved tactile comfort and reduced risk of skin irritation.
Kalazić et al. (Fri,) studied this question.