A 6 to 12-GHz Fractional-N Frequency Synthesizer With a Digital Technique to Counter Modulus-Dependent Feedback Divider Delays

This article presents a frequency synthesizer for generating quadrature local-oscillator (LO) waveforms covering an octave range of 6 to 12-GHz. It uses two voltage-controlled oscillators (VCO) to cover an octave range from 12 to 24 GHz. The VCOs employ inductor mode switching in addition to conventional capacitor switching to obtain a wide tuning range while maintaining a good phase noise figure of merit (FoM). Modulus-dependent delay (MDD) of the feedback divider increases jitter in fractional- N mode. The delay change can exceed 100 ps when the number of stages in the divider chain changes. A new digital technique, which can be realized with minor modifications to the conventional digital delta-sigma modulator (DDSM), is implemented to overcome this effect. The delay change is turned into a periodic error at half the reference frequency that is then filtered by the loop filter. The prototype synthesizer in 65-nm CMOS occupies 0. 54 mm² and consumes 66 mW at the highest frequency from a 1-V supply, including buffers and dividers. The nominal loop bandwidth is 280 kHz. The integrated jitter is dominated by the VCOs and is 400, 300, and 500 fs in the 6 to 8-GHz, 8 to 10-GHz, and 10 to 12-GHz ranges, respectively. The worst case reference spurs are below -60 dBc and the fractional spurs are below -31 dBc.