Effect of Mo on Microstructure and Mechanical Properties of Corrosion-Resistant Tank Steel

To enhance the safe service performance of corrosion-resistant tank steel, it is of significant importance to develop novel materials characterized by both high strength-toughness and a low yield ratio. In this study, four experimental steels with a gradient of Mo content (0, 0.15 wt%, 0.30 wt%, and 0.60 wt% Mo) were prepared via thermomechanical controlled processing. The influence of Mo on the microstructural evolution and mechanical properties of the base metal was systematically investigated. The results revealed that when the Mo content was ≤0.15 wt%, the primary constituents of the matrix microstructure were polygonal ferrite, acicular ferrite, and granular bainitic ferrite. As the Mo content increased to 0.30 wt% and beyond, lath bainitic ferrite (LBF) emerged within the microstructure, and the size of the hard martensite/austenite constituents exhibited a refinement trend with increasing Mo content. Elevated Mo content enhanced the strength of the base metal, while the impact toughness initially increased and subsequently decreased. The equivalent grain size defined by misorientation tolerance angles of 2–6° contributed most significantly to the yield strength, as evidenced by its higher Hall–Petch fitting coefficient. The improvement in impact toughness was primarily attributed to the refinement of M/A constituents, which reduced crack initiation susceptibility, and the high density of high-angle grain boundaries (HAGBs) provided by the acicular ferrite. Conversely, the degradation in toughness was directly correlated with the coarsening of HAGB size and the reduction in HAGB density induced by the formation of LBF.