Answers are grounded in this paper and cite their sources.
The research examines deformation and fracture characteristics of 3D printed Ti-6Al-4V/TiC composites, suggesting particle size impacts ductility.
The deformation and fracture patterns of 3D printed Ti-6Al-4V/TiC composites produced by wire-feed electron beam additive manufacturing using Ti-6Al-4V wire pre-electrospark alloyed with carbide containing electrodes or by simultaneous melting of titanium wire and TiC powder were investigated. It is shown that Ti-6Al-4V/TiC composites obtained by both methods are characterised by the same microstructure and volume fraction of carbide phase (~2%), but different sizes of TiC inclusions. It was found that the ductility of the Ti-6Al-4V/TiC composite obtained by electrospark alloying of the wire and containing TiC inclusions with a diameter of ~1 μm is significantly higher than that of the sample 3D printed by simultaneous melting of titanium wire and TiC powder, in which the inclusion sizes vary within 15-30 μm. The different fracture characteristics of the investigated Ti-6Al-4V/TiC composites under uniaxial tensile stress were revealed. Three-dimensional modelling of elastic-plastic deformation and fracture of model Ti/TiC composites under mechanical loading was carried out using the method of moving cellular automata. The influence of the size and hardness of the TiC particles, as well as the character of their distribution in the titanium matrix, on the regularities of crack initiation and propagation in the model composite was demonstrated. It was shown that the inhomogeneous distribution of large carbide inclusions in the titanium matrix is a key factor for crack initiation and propagation in the model composites.
No takes yet. Share an insight, caveat, or question.
PANIN et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: