Answers are grounded in this paper and cite their sources.
Qualitative test reveals safe limits for total dissolved solids, electrical conductivity, and pH in water, indicating overall good quality.
The investigation aimed to assess the quality of the water in terms of Total Dissolved Solids (TDS), Electrical Conductivity (EC), pH, Hardness, Alkalinity, and Turbidity, with comparisons made against established safety limits. Water samples were collected from various points along the distribution network, including and the treatment plant, the reservoir, households 1, 2, and 3,. The results revealed that the TDS levels ranged from 98 ppm to 158 ppm, all within the safe limit range of 50-150 ppm. EC values were measured below the safe limit of 400µS/cm, indicating good conductivity and low ion concentration. pH levels varied slightly, with most falling within the acceptable range of 6.5-8.5, except for one household which exceeded the upper limit. Hardness levels were below the safe limit range of 120-170mg/L, indicating soft water quality. Alkalinity values fell within the safe limit range of 30-400 ppm, suggesting adequate buffering capacity. Turbidity measurements were all below the safe limit of <1 NTU, indicating clear water free from suspended particles. Microbial analysis revealed that there was 4 and 32 Coliform/E. coli after 24 hours for Household 3 and treatment plant, respectively; all the households experienced TNTC of total plate count exception of treatment which had 40. Yeast and mould after 72 hours was observed to be 7, 60, and 50 for household 1, 3 and treatment plant, respectively; after 120 hours household 1 and, treatment plant had counts of 13, 71, and 83, respectively.
No takes yet. Share an insight, caveat, or question.
Oboyi Matthew Echeofun (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: